9,372 results
Two offshore crane battery ruptures prompt guidance on inspecting batteries and charging systems and controlling stored-energy, chemical and ignition hazards during handling.
Reports a loss of diesel containment during fluid transfer.
Fuel biocide used to clean strainers soaked through cotton coveralls; delayed washing and reuse of contaminated clothing prolonged skin exposure and caused severe burns.
A mobile scaffold with seized wheels collapsed three deck levels while being lifted over an obstruction, with no exclusion zone below.
Explores a tank overfill and diesel release to sea, examining workload, handover, task design and failed overfill protection, with improvements and discussion questions.
Describes a back injury sustained when moving a partially filled coolant container.
Maintenance inside a tether management system junction box proceeded after another ROV system was isolated and grounded, leaving the target equipment without electrical isolation.
Two basket-transfer incidents involved unexpected descent of crane auxiliary lines, highlighting maintenance, known deficiencies, stop-work authority, communication and medical evacuation planning.
A slipped hogging line disrupted a saturation diver’s position, bringing an 8000 psi water-jetting nozzle across the foot and causing an injection injury.
An attempted vessel transfer without approved access was stopped after both bridges failed to intervene, highlighting ineffective controls and acceptance of unsafe behaviour.
A worker fell through an open grid mesh floor penetration during vessel engine room inspections, catching an arm and avoiding a longer fall.
A scaffold inspector tripped over a diagonal brace after using a tablet; messages emphasise spatial awareness, clear access routes and good housekeeping.
Compiles drilling incident counts, hours worked and injury rates through the third quarter of 2026, by region and onshore or offshore operations.
BSEE has published Safety Alert 517 relating to poorly maintained crane components.
A crew member sustained second-degree chemical burns while cleaning fuel oil strainers.
A diver suffered a foot injury whilst working with high pressure water jetting (HPWJ) equipment.
A rigger sustained a cheek abrasion while repositioning a heavy chain block during rigging preparation.
There was a high voltage isolation near miss when crew were working on a TMS (Tether Management System).
The alert describes how incorrectly identified ring-type joint materials contributed to corrosion and a hydrocarbon leak, highlighting verification and supplier assurance.